DIY Tips for Unclogging Sinks and Drains to Save Your Staten Island Property

It is an unpleasant fact that drains and sinks in your home will clog from time to time. That should not cause you to panic or contemplate relocating to a different home. It is always good to hire a technician with the appropriate tools, experience, and training to unclog these drains. However, it can cost a lot of money to hire professionals. In such instances, you should consider DIY unclogging.

When Fixing a Clogged Sink, a DIY Guide like this one will help you figure out what you need to do. Below are a few tips to help you do this job properly.

Prepare the tools

First, prepare all the tools you need for the job. You can do a lot with nothing more than a plunger and snake. In fact, these two tools can fix almost 95% of all clogged drains or sinks. What is more, you only need a maximum of one hour to restore your drains back to the excellent condition they were in before the clogging arose. Only the most stubborn clogs can refuse to give in to the incredible job these tools do. Visit the local home center or hardware store to buy the plunger and snake.

Use the Plunger

Once the tools are in place, the next task is to use the plunger in clearing the blockage. Plunging the drain is highly recommended in case the problem is not with the disposer. Those with dishwashers should always begin by clamping the drain hose. Fill the sink with water (about 3-4 inches of water) to allow the plunger to seal the drain properly. Once this is done, you should plunge away.

Clean the P-Trap

The P-trap needs cleaning too. Your DIY unclogging of the drains or sink is never complete until you give the P-trap all the attention it craves. You will realize that it is impossible to clean it without first disassembling it. The clogging on this part of the drains occurs when grease builds up and sticks. In some instances, you can clean the P-trap with a bit of plunging. Only consider disassembling when plunging does not work or produce the desired results.

Snake the Line

Next, snake the line. Do not stop snaking even if you feel the cable hitting a barrier or obstruction. Crank and push the cable until the barrier gives way. It is easier to know when the barrier has given way – the tension on the cable will drop. Once you force your way through the cable, crank the cable counterclockwise before pulling it out. Do not forget to clean the cable while pulling it out since it will be covered in dirt and the debris that clogged the drains.
Investing in a good drain cleaner is highly recommended too. This can be found at the local home
improvement or hardware store.

Use Vinegar and Baking Soda

In some cases, especially where the clog is not too severe, you could use vinegar and baking soda to unclog the drains. Vinegar is a great cleaner for individuals who do not wish to use chemicals. The fizzing reaction produced when you follow up the vinegar with a sprinkle of is highly effective at unclogging minimal sink clogs. If the mix does not produce results, go ahead and hire a technician or try a different method.

Contact Staten Island Plumber for solutions regarding your clogged sinks.

Categories: Commercial Services


Leave a Reply

Your email address will not be published. Required fields are marked *